Select a Category
Build Author Venturebit Views 399
SHRED-Buddy3D UPcycler - Open Source Multi Material Cutter&Pelletizer
The whole system is powered by 12V / DC power. Process it into Pellets or Granules to use it with your 3D Printer or Filament Extruder. Our self-developed steppermotor Controls allows you to optimally adjust Feedrate for your Situation. Forward, Backward and Stop is integrated for easy operation. The Speed can be continuously regulated via rotary switch.
Build Author Julius Views 7787
OX Balls - 1605 Ballscrew Powered 1000mmx1000mmm OX derivative
1000x1000mm Ballscrew driven OX Derivative. Dewalt 611 spindle and TB6600 Drivers.
Build Author Rob Taylor Views 12362
DSLR Video Slider
A simple 1500mm V Slot camera slider for timelapse and possibly video with an Arduino Uno controlling a Pololu A4988 driving an OpenBuilds NEMA 17 stepper, and triggering the camera.
Build Author Anglesachse Views 4384
Corexy, with possible head change (3d, cnc, laser)
Build Author Keteland Views 3316
MULIMATERIAL 3D PRINTER (in progress)
ELECTRONICS - ARDUINO Mega 2560 + RAMPS 1.4 + power supply 12V - Leadshine DM 5042 external driver + Power supply 36V + NEMA 23 stepper motor SOFTWARE - Repetier Host to communicate with the Ramps - ARDUINO to upload the firmware (Marlin) MECANIC - V-Slots rails 40x40 + home-made plates - everything goes fine on the side of the build
Build Author Gerrald Views 1156
This build is to show what's possible as well with openBuilds! I use a single ArduinoMega and 5 separate stepper drivers (A4988). The LEDs are all NeoPixels. Collision 'detection' is all done within the code, so the endstops are only sensors I use in this build. I'm a self-employed video-artist and this is my first installation which just needs power and it runs (where I'm quite proud of). Normally my interactive installations take a long setup time, so this installation is a relief :)
Build Author David Arroyo Views 6732
Using a Raspberry Pi, Arduino and a Protoneer CNC Shield to create an Open Source CNC router controller. It will be equipped with a touch screen to control the on board processor. The touch screen will run a user interface that has buttons for added functionality. There will be a camera for monitoring progress from inside my office. The control box will also feature a way to power the vacuum and spindle/router . I will also be able to monitor room temp as well as Pi CPU temps and averages.
Build Author Justin Butler Views 3171
My Belt & Pinion Drive CNC Router
My CNC Router design and inspiration came from the Routy CNC project. I modified some of the aspects of the Routy build, but left the original XY dimensions intact. The build has been very enjoyable thus far and am nearing completion of all wiring in preparation for my first test run!
Build Author zelos Views 7291
ZelosLaser Engraver/Cutter 2.0 : Sturdy & Versatile
Zelos Laser Cutter Version 2.0 GRBL Shield with Nema 17 motors. 2 Watt laser for cutting and fine grayscale pictures built very sturdy and modular
Build Author Cuong Vu Views 10511
Camera slider for stacking focus
This is just a small project to get use to the OpenBuild products.
Build Author Ivan Walker Views 3731
HardKnot OX 4x4
I've been working on commercial woodworking CNC's for year's under shop owner's that didn't want me to progress any further at a certain point. This is a project I've wanting to build for about 10 years now. I can't wait for the freedom to build what I know is possible without any negative input.